Garage Insulation 101

Though often overlooked, your garage is one of the most important rooms in the house. It’s also one of the largest. It gets used several times everyday. It acts as a main storage unit. Plus, if you have an attached addition, it probably becomes your most accessible entryway, which makes your garage door more like your front door. However, since this room is often considered an outbuilding (even when it’s attached) it tends to be neglected. Usually these spaces are not properly sealed, hazard-proofed, and typically remain uninsulated, making them inefficient and possibly dangerous.

Why Garage Insulation?

What’s the point of insulating every nook and cranny around the house just to let air seep in and out of the garage, especially since these spaces are known for fluctuating temperatures: they’re steamy in the summer and freezing in the winter? So whether the area is small or large, and whether you use it a lot or not, it’s vital to install garage insulation. It helps to prohibit air seepage, heat transfer, health threats, and most importantly, it saves on unnecessary energy costs. You may even spend more time out there once the climate has become better regulated due to proper insulating.

Where Does It Go?

If garage insulation is just installed in the one wall edging your home’s interior, you’ll already be saving tons on energy costs: a lot of air escapes and heat is transferred between this particular partition. Plus, by law, insulation in this wall is required to be fire-rated (due to the high probability of combustible liquids stored in this “room” and its lack of smoke detectors), which adds an extra layer of safety to the space. And don’t forget the ceiling: If an attic or bedroom rests above, insulating this “horizontal wall” is crucial. Also, you can insulate the door with ready-made kits that seal and prevent any problematic air gaps.

Which Garage Insulation Is Best?

There are a couple options when it comes to insulation. Each depends on your budget, whether you do it yourself or hire a contractor, and your personal needs:

  • Batt insulation: This cotton-fiberglass material is fairly inexpensive and easy to use: simply place it in between the studs, staple a vapor barrier to cover it, and you’re in business. However, for it to work effectively, you’ll need to wall it up as well. Therefore, you’ll need to buy and install 1/2-inch drywall around the room (though ceiling and walls adjacent to living areas typically require 5/8-inch drywall). This may require the work of a garage contractor, depending on how handy you are and how good you want the final product to look. It adds to your cost but if it’s worth being done, then it’s worth being done right.
  • Blown-in insulation: If you already have drywall installed around your garage but don’t have it insulated, then blown-in insulation may be the answer. A contractor will come and open up a hole in the wall, pump in a cellulose insulating material, and then patch up the opening. Blown-in insulation is quick and can be done within a few hours without any additional demo or reinstallation. However, it may be a bit more expensive since contractors usually charge a minimum fee no matter the size of the space or the time it takes.
  • Foam board: If you don’t want to install drywall, you may be able to cover the batt insulation with rigid foam board. But check with your local building codes to make sure it has a radiant barrier and guarantee that it is flame tested.

Proper Sealing

Once the garage insulation is installed, it’s important to take a quick inspection of the area. Since there are a lot of dangerous chemicals around this space, and since cars give off a lot of exhaust (and dangerous carbon monoxide), you’ll want to be sure everything is sealed off. Caulk around the bottom of the drywall and seal it to the floor. Weatherstrip the door leading into the house. Possibly buy a metal door for extra fire safety and always make sure it self-closes. And examine around any windows, electrical outlets, and the garage door for air leaks that may need to be addressed to ensure energy efficiency.

-From HomeAdvisor.com

1 Results
4
Beds
2 | 1
Baths
2,336
SqFt
 
 
#VAFC2004244 | House
 
© 2024 BRIGHT. All rights reserved.
The data relating to real estate for sale on this website appears in part through the BRIGHT Internet Data Exchange program, a voluntary cooperative exchange of property listing data between licensed real estate brokerage firms in which Brodie Realty Group Inc. participates, and is provided by BRIGHT through a licensing agreement. Real estate listings held by brokerage firms other than Brodie Realty Group Inc. are marked with the IDX icon, and detailed information about each listing includes the name of the listing broker. The information provided by this website is for the personal, non-commercial use of consumers and may not be used for any purpose other than to identify prospective properties consumers may be interested in purchasing. Some properties which appear for sale on this website may no longer be available because they are under contract, have Closed or are no longer being offered for sale. Home sale information is not to be construed as an appraisal and may not be used as such for any purpose. BRIGHT MLS is a provider of this home sale information and has compiled content from various sources. Some properties represented may not have actually sold due to reporting errors. Some real estate firms do not participate in IDX and their listings do not appear on this website. Some properties listed with participating firms do not appear on this website at the request of the seller. Information Deemed Reliable But Not Guaranteed.
BRIGHT(MRIS/Trend) data last updated at March 28, 2024 12:15 PM ET